What would cause a Hyundai Sonata not to start?
The most common reasons a Hyundai Sonata won’t start are a dead battery, an alternator problem, or failed starter.
Why is my Hyundai car not starting?
A Hyundai that doesn’t start can have a range of causes including dead battery, poor battery connection, dead key fob, broken starter, blown fuse, fuel pump failure, clogged fuel filter, empty fuel tank, defective spark plugs or any other electronics failure.
Where is the starter located on a 2004 Hyundai Sonata?
Where is the starter located? The starter bolts up to the transmission bell housing at the side of the engine.
How do you jumpstart a Hyundai Sonata?
antennamediatorino.eu
Our red cable. First. If you're using another car and a set of jumper cables to jump this go ahead and make sure that the other car is off while you're jumping while you're hooking up all your cables.
How do I start my Hyundai Sonata with a bad starter?
First connect red cable to the positive terminal of your Sonata’s dead battery, then to the positive terminal of donor battery. Next connect black cable to the negative terminal of donor battery, then to the bare metal in the engine bay of your Sonata. Start the donor vehicle and then your Sonata.
How do you reset the anti theft system on a Hyundai Sonata?
Use the ignition key to unlock the Sonata doors, then open the door and enter the driver’s seat. Put the key into the ignition and turn the ignition cylinder clockwise as far as it will go before cranking the Sonata engine. Leave the key here for 30 seconds to deactivate the system.
How do I reset my Hyundai Immobiliser?
To reset the immobilizer, hold down the panic button. Wait for ten minutes if you push the lock button two times.
Are there any recalls on Hyundai Sonatas?
Hyundai Motor America (Hyundai) is recalling certain 2020 Sonata and Sonata Hybrid, and 2019 Genesis G70 vehicles. The trunk latch may become damaged, preventing the opening of the trunk from the inside.
How do you unlock the steering wheel on a Hyundai Sonata?
The solution is very simple: with some force, pull the steering wheel from left to right while simultaneously trying to insert and turn the key. You’re looking for the sweet spot where the tension on the ignition lock disengages just enough to let you operate the key and fully unlock the steering column.
How long does it take to jump start a car?
Answer provided by. Jumpstarting your car should only take about 5 minutes once you have the cables hooked up. If it won’t start after leaving it connected for 5 minutes, your battery’s either dead or being jumped wrong.
How do you open a Hyundai Sonata trunk with a dead battery?
To open the door, pull the lock tab up, and use the outside door handle. As a safety feature, your vehicle has a release lever on the right corner in the trunk so the trunk can be opened from the inside.
How do you jump a Hyundai?
The Proper Way to Jump Start a Car
- Have the car with the good battery park facing the other vehicle, then make sure that vehicle is turned off. …
- Open both hoods and find the batteries. …
- Identify the positive and negative terminals. …
- Connect the red clamp to the positive post on the dead battery.
How long do jump leads take to work?
The lead must be a good distance from the battery. Ensure that the jump leads will not touch any the moving parts of either of the engines. Wait three minutes for the voltages to equalise.
When jumping a car should you rev the engine?
Increasing the engine speed on the donor vehicle makes sure enough amperage (current) flows to the weak battery. Yes, it is helpful to rev the engine and hold it around 1,200 rpm.
Where do you ground negative battery cables?
The negative (black) cable should have one end attached to the negative terminal of the dead battery, and one end grounded. The safest order to attach the jumper cables is as follows: Attach one red jumper cable clamp to the positive terminal on the dead battery.
What terminal do you hook up first on a car battery?
Positive
“Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”
What supplies power to vehicle electronics while the battery is disconnected?
Use a battery saver, 12-volt power supply or battery charger to maintain voltage to the vehicle’s electrical system when disconnecting the battery or when replacing a battery.