2013 Focus SE Dash Vents not blowing AC or heat, all other vents work fine

Why is there no air coming out of my vents in my car?

Here are some of the most common causes of why air doesn’t flow out of your vehicle’s vents: Your air intake is clogged, meaning that air isn’t getting in from the outside at all or isn’t circulating properly. There is a blown fuse in the ventilation system. Electrical issues such as a bad relay.

What controls the AC vents in a car?

Q: What controls the vents in a car? The vents for modern vehicles are controlled by three or four electrical actuator motors, which can be adjusted by the climate control module; this electronically regulates and control the air ventilation system in your vehicle.

Why is my AC not blowing out the front vents?

If that filter is clogged up you will not get the correct amount of flow out through the vents.

How do you unclog car AC vents?

Method 1

  1. Step 1: Warm Water and White Vinegar (with or without lemon juice) or Lemon Scented Cleaning Vinegar. Equal amounts of white vinegar and warm water can be combined to make a homemade car air vent cleaner. …
  2. Step 2: Foam Paint brushes. …
  3. Step 3: Microfiber Towel. …
  4. Step 4: Dish Detergent and Warm Water.

How do I know if my car AC fuse is blown?


Why is my heat and air not working in my car?

If the heater isn’t blowing hot air at you when you turn the system on, the blower fan might have a problem. Either it’s not getting electrical power or, more likely, the motor itself has simply burned out. A blower motor in an older vehicle is likely to burn out over time, and may need replacement.

What actuator controls the vents?

The mode door actuator controls which vent(s) air blows through. The door on this actuator has two positions: closed and open. Today, most actuators are controlled electronically. As actuators wear over time, the plastic gears inside may be stripped or broken, causing them to fail.

What controls your heat and air in your car?

The blower motor blows air through the heater core and to the passenger compartment inside of your automobile. The heater control valve is the device that controls the flow of the hot engine coolant through the heater core. It is usually located in one of the heater hoses to regulate this flow.

Where is the blend door actuator located?

The blend door actuator(s) are typically located on the climate control case behind the dashboard.

How do you know if your car AC is clogged?

But sometimes it cools and sometimes it doesn't so we're gonna check various spots to see if there are any hot or cold spots showing. It's clogged.

How do I increase the airflow in my vents?

Increasing airflow in ductwork can be done by cleaning the air filters and ductwork. By adding inline duct booster fans and/or air dampers significantly can improve airflow in weak areas.

How do you check air duct flow?

An anemometer, a test instrument that measures air velocity is used to determine the average airspeed in the duct. Then the average feet per minute is multiplied by the area of the duct in square feet to determine the airflow moving through the duct.

Will duct cleaning improve the airflow?

After testing 33 homes in Montreal before and after duct cleaning, the study found that there was no significant improvement in air quality and that duct cleaning alone did not improve airflow or energy efficiency. In some cases, measured particle levels actually increased immediately after a cleaning.

How do I know if my return air is working?

Try this simple test when your HVAC system is running: get a piece of tissue paper and dangle it about six inches from one of the return vents. You should be able to see it being gently pulled towards the vent. Next, place it up against return vent and see if the air suction holds it in place.

How can you tell if an air duct is clogged?

The biggest symptom of clogged air ducts in your home is a difference in temperatures. This is most likely to occur if you set your whole-home thermostat to the desired temperature and then notice that one room isn’t as warm or cool as the others.

How do you tell if a duct is blocked?

You can generally identify a blocked air duct by a distinct drop in heating and cooling efficiency, increased energy costs and occasionally a musty, dusty smell throughout the home. Blockage usually comes over time, by a buildup of dust and debris that just accumulates until it begins choking the system.