Clearing an obd 1 check engine light

How do you reset check engine light on OBD1?

antennamediatorino.eu
You can go ahead and take the paperclip out and then close the lid and you clear the coats all you have to do is just disconnect the battery.

Can you clear check engine light with OBD2 scanner?

You plug an OBD-II scanner tool into it and, in most cases, out pops a code that tells you what the problem is. The scanner also allows you to clear the vehicle’s internal code, which is what triggered the check-engine light. Do that, and the warning light will turn off.

How do you delete OBD 1 codes?

Disconnect the battery for 5 minutes.



Cutting power to your vehicle will allow the ECU to reset, and once you reconnect power, it should clear any OBD1 codes that your Honda was presenting.

What happens when you clear an OBD code?

What Happens When You Erase Obd Codes? When the “Erase Codes” function is used, the system status is changed to “Not Ready”. You will drive for 50 to 100 miles (80 to 160 km). Once the system has read the status of all components again, take several trips to check them all out.

How do I reset my check engine light without a scanner?

How to Reset a Check Engine Light Without a Scanner. To reset a check engine light without a scanner, disconnect the negative battery cable and wait a few moments. This will reset the diagnostic system in your vehicle, and if the underlying issue has indeed been resolved, the light should go off immediately.

Does disconnecting battery clear codes?

Disconnecting the battery will clear the error codes and reset the check engine light.

Is it illegal to remove check engine light?

The check engine light can be disabled by a dealer without violating the law. Although it is illegal for you to reset it after you do a service or a scan, you cannot be punished criminally.