What the P0011 code means. P0011 is the OBD-II generic code indicating the engine control module (ECM) has determined that the bank 1 intake camshaft is more advanced than what the ECM has commanded it be. This over-advanced condition could be during advancing or retarding of the camshaft timing.
Can I drive with code P0011?
Driving with a P0011 code in your car is possible, though not advisable. Do not drive with it until you repair it because it can cause severe damage to your car engine components. By ignoring the P0011 error code in your car, the vehicle will emanate several drivability issues.
What can cause a P0011 code?
P0011 Causes
- Engine oil is dirty.
- Engine oil is too low.
- Engine oil is incorrect viscosity.
- Camshaft variable timing solenoid failure.
- Camshaft phaser is seized in the advanced position.
- Continuous oil flow to Variable Camshaft Timing chamber.
How do I fix the timing on my camshaft position?
Zitat von Youtube: Use a valve cleaner to clean the camshaft oil control valve. Then use a multimeter to proceed a test on the camshaft.
How much does it cost to fix a P0011?
If the engine is relatively new or has low-mileage, the cost of fixing the P0011 code will cost no more than a basic oil change (around $30 to $50). In most cases, the P0011 OBD2 Trouble Code is caused by dirty oil.
How do I fix code P0011?
What repairs can fix the P0011 code?
- Resetting the fault codes and performing a road test.
- Changing the oil and filter to the proper oil viscosity for the engine specifications.
- Repairing or replacing the wiring to the camshaft oil control valve for bank 1 intake camshaft.
Is P0011 serious?
Fault code P0011 is specific to vehicles that utilize variable valve timing in a bid to increase engine operating efficiency. Engines featuring variable valve timing make subtle timing adjustments on the fly, which effectively vary the point at which each cylinder’s intake/exhaust valves actuate.
What does intake a camshaft position Timing Over Advanced Bank 1?
What Does the P0011 Code Mean? The P0011 DTC stands for “A” Camshaft Position Timing Over Advanced or System Performance Bank 1. The code indicates that the ECM/PCM has been unable to correct a detected difference in the desired camshaft position angle and the actual camshaft position angle.
Where is the camshaft position sensor located?
The Camshaft Position sensor is typically located in the cylinder head of the engine and has a cylindrical portion that inserts into the head. The Crankshaft Position sensor is normally located in the timing cover or on the side of the block with a cylindrical portion that inserts into the block.