P0017 DODGE code

P0017 is the OBD-II generic code indicating that the crankshaft and camshaft position sensor for bank 1 exhaust camshaft do not correlate signals with each other.

How much does it cost to fix P0017?

The cost of fixing error code P0017 varies, depending on the culprit. If a scan tool confirms the camshaft position sensor is the cause, the budget to spend around $25 to $80. The amount here is for the replacement sensor alone.

What causes P0017?

These are some of the possible issues that can cause a code P0017: Damaged or stretched timing chain or timing belt. Faulty camshaft or crankshaft reluctor wheel. Bad crank sensor.

What is bank1 sensor B?

Note that the “B” means that this sensor is located in the exhaust side of the cylinder head. Bank 1 means that the sensor is located in the engine bank with cylinder 1.

Can low oil cause P0017?

Causes of Code P0017



But before you start removing any bolts, check your engine oil first. While it’s not the most common cause of a code P0017, if your engine oil is extremely low, it might cause the problem. Furthermore, if you have used the wrong engine oil, this code might crop up too.

Is code P0017 serious?

What the P0017 code means. P0017 is the OBD-II generic code indicating that the crankshaft and camshaft position sensor for bank 1 exhaust camshaft do not correlate signals with each other.

How do you fix a camshaft position sensor?


Zitat von Youtube: If it has repair the leak to prevent the new sensor from being damaged. Check to make sure the o-ring from the sensor hasn't fallen into its hole push. The new sensor into place and replace the bolt.

Where is camshaft position sensor B located?

Zitat von Youtube: The camshaft position sensor is located in the valve cover near the top of the engine. Or they can be located at the front or rear of the cylinder.

Where is the bank 1 camshaft position sensor?

Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.

Can camshaft position sensor be cleaned?

Zitat von Youtube: Most probably is an even and initially about Center.

What is a camshaft bank 1?

Alternatively, if the engine employs a V configuration, the “A” typically refers to Bank 1’s intake camshaft. Finally, the “bank 1” in the P0341 code refers to the side of the engine where the number one cylinder is located.

Where is the crankshaft position sensor located?

The sensor is at either the front or the back of the crankshaft, so it’s usually located either on the transmission bellhousing or behind the crankshaft pulley. There should be a small air gap, usually about a millimeter or two, between the sensor and the reluctor.