What the P0020 code means. P0020 is the OBD-II generic code indicating that the engine control module (ECM) has determined that the bank 2 intake camshaft Oil Control Valve (OCV) has an open or short circuit. This happens during one drive cycle.
What does P0020 mean?
Intake Camshaft Actuator Circuit Open/Short
What Does Code P0020 Mean? P0020 definition: Intake Camshaft Actuator Circuit Open/Short (Bank 2) Issue Severity: MODERATE – Extended driving with this code may cause internal engine damage. Repair Urgency: Get this code fixed as soon as possible to avoid damage to the engine and emissions system.
What is a camshaft position actuator circuit open bank 2?
Diagnostic Trouble Code (DTC) P0020 stands for “Intake “A” Camshaft Position Actuator Circuit / Open (Bank 2).” It is triggered when the powertrain control module (PCM) detects that the voltage from the variable valve timing circuit has fallen out of specification for a calibrated amount of time.
Where is the camshaft actuator located?
camshaft gear
A camshaft actuator is a mechanical or electronic device that is mounted on the camshaft gear.
What is a camshaft position actuator circuit Bank 1?
Code P0010 stands for “A” Camshaft Position Actuator Circuit (Bank 1). The code indicates that your car’s primary computer, which is also referred to as the powertrain control module (PCM), perceives a problem with one of the engine’s VVT solenoids.
How do I fix code P0020?
What repairs can fix the P0020 code?
- Clearing the fault codes and testing the system to verify the code.
- Repairing or replacing the wiring to the intake camshaft oil control valve for bank 2.
- Replacing the camshaft oil control valve for bank 2 intake camshaft.
- Replacing the ECM if directed from pinpoint tests.
Where is the intake camshaft position actuator solenoid?
The intake camshaft actuator features a gray electrical plug and is located closer to the front of the vehicle on the top of the cylinder head.
How do I fix code P0345?
What repairs can fix the P0345 code?
- Replacing the crankshaft position sensor.
- Repairing or replacing damaged wiring.
- Repairing loose connections.
- Identification and repair of fluid leaks.
What causes code P0022?
Code P0022 is logged when the PCM perceives an over-retarded or over delayed timing condition in Bank 2 of the intake camshaft. The crankshaft and camshaft position sensors relay information to the PCM. The module uses the data to determine whether the engine is timed properly by comparing the input from both sensors.
How do I fix code P0014?
What repairs can fix the P0014 code?
- Replace camshaft timing control valve solenoid.
- Repair wirings to camshaft timing control valve solenoid.
- Clean oil lines to VCT or VVT system.
- Replace valve control unit (VVT or VCT, for example)
- Replace timing belt or timing chain.
- Replace camshaft position sensor.
How much does it cost to replace a camshaft adjuster solenoid?
The Best in Auto Repair
The average cost for camshaft position sensor replacement is between $176 and $227. Labor costs are estimated between $72 and $90 while parts are priced between $105 and $136. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
How much does it cost to fix code P0013?
These sensors typically cost between 25 and 50 dollars and are usually pretty easy to replace. It’s a pretty low-risk part and job to fix a severe problem.