The meaning of the P0038 OBD2 Trouble Code is a mouthful, but basically the ECM is detecting a problem in the heating circuit in O2 sensor #2. This O2 sensor is located downstream or after the catalytic converter. This usually means you gotta wiring issue.
How do I fix code P0038?
In most cases, replacing the faulty oxygen sensor will eliminate the problem responsible for the P0038 code. The exact fix, however, will likely differ based on the make and/or model of the vehicle.
What does heater control circuit high mean?
What the P0052 code means. This code is seen when the Engine Control Module (ECM) tries to control the heater control circuit for Bank 2 Sensor 1 and finds high voltage present. The heater is an integral part of sensor function that is used to heat the oxygen sensor to operating temperature until the vehicle warms up.
Where is the heat oxygen sensor located?
Oxygen sensors are located in the exhaust manifold or exhaust pipe of the engine’s exhaust system. The sensor measures the oxygen content in the exhaust stream and sends an analog voltage signal to the ECM that varies between 0 and 1 volt.
What causes a heated oxygen sensor?
There are several potential causes of the HOS2 code: * The fuel/air ratio (or O2) sensor may be faulty. * The O2 sensor could have a faulty electrical connector. * There may be a short or other fault in the O2 sensor circuit wiring. * An oxygen sensor fuse may be blown.
What does engine code P0032 mean?
P0032 sends sensor data for the engine to operate properly as the engine exhaust should have a specific air-fuel ratio of 14.7 to 1 as detected by the heated oxygen sensors (HO2S) which defines the oxygen content of the vehicle exhaust. This code is for the HO2S in front of the catalytic converter.
What does engine code P0058 mean?
What the P0058 code means. When this code is stored in the powertrain control module it means that the heater control circuit in the oxygen sensor after the catalytic converter on the cylinder bank not containing cylinder one has higher voltage than expected.
How do you fix a heater control circuit?
Zitat von Youtube: Manifold. Visually check the oxygen sensors electrical connections wire harness and metal tabs for any damages. If the damages are found then replace the oxygen. Sensor.
Which 02 sensor is bank 1 sensor 2?
Zitat von Youtube: Usually on your exhaust monitor guys on the exhaust.
What is circuit High bank1?
Diagnostic trouble code (DTC) P0132 stands for “Oxygen Sensor Circuit High Voltage (Bank 1, Sensor 1).” It involves the vehicle’s oxygen sensor, specifically the #1 sensor on Bank 1. This code is triggered when the PCM or powertrain control module detects that your heated oxygen sensor reading is too high.
Is there a fuse for oxygen sensor?
yes, there is a fuse for the o2 heaters. check all the fuses. it may also be a harness issue and needs to be checked as well.
How do I know which oxygen sensor to replace?
Zitat von Youtube: You can know for sure which of your o2 sensors is indicating a problem by having your code scanned. You can have your code scan for free at your local O'Reilly Auto Parts Store.