OBD Code P014B is stored when the powertrain control module (PCM) detects a delayed response time from the downstream (or post catalytic converter) oxygen (O2) sensor or circuit for engine bank two.
How do I fix code P015B?
Zitat von Youtube: In order to prevent leaking get some gasoline put it in a cup and then dip the new fuel injector into it. So the seals may get wet with gasoline.
What does code P013E mean?
What Does the P013E Code Mean? Diagnostic trouble code (DTC) P013E stands for “O2 Sensor Delayed Response – Rich to Lean (Bank 1, Sensor 2). It is logged when the powertrain control module (PCM) perceives a delay in response from the downstream oxygen (O2) sensor located in bank 1.
What does code p015c mean?
Zitat von Youtube: But your vehicle should be repaired asap p015c means that the pcm has detected a delayed response time from the upstream oxygen sensor circuit for engine bank.
What does code P013B mean?
Diagnostic trouble code (DTC) P013B stands for “O2 Sensor Slow Response – Lean to Rich (Bank 1, Sensor 2).” This code is logged once the powertrain control module (PCM) detects that oxygen sensor 2 in bank 1 of the engine is taking longer than expected to switch from rich (a higher output voltage) to lean (a lower …
What causes P015B?
P015B code means that your vehicle’s powertrain control module (PCM) has detected a delayed response time from the upstream oxygen sensor on Bank 1. Usually, a slight decrease in fuel economy will be the result, along with an MIL light.
What causes O2 sensor slow response?
The slow response of an O2 sensor may be due to a sensor that is just getting old and over time may get contaminated with time with carbon and other contaminants that deteriorate the sensor over time.
What does code P2270 mean?
O2 sensor signal stuck lean
P2270 is an OBD-II generic code for the O2 sensor signal stuck lean on bank 1 sensor 2 to the engine control module (ECM). This means that the O2 sensor in bank 1 sensor 2 indicates either too much oxygen in the exhaust stream, an open circuit, or a defective sensor which causes a lean signal to the ECM.
What does P0140 mean?
P0140 is the OBD-II generic code which indicates that the O2 sensor for Bank 1, Sensor 2 failed respond to the fuel cutoff or fuel enrichment signals by the Engine Control Module (ECM).