What the P0160 code means. This code means that the powertrain control module has detected a fault in the circuit for the oxygen sensor for bank 2 sensor 2. The Check Engine Light will illuminate to let the owner know that there is a problem with the emissions system.
How do I fix code P0158?
What repairs can fix the P0158 code?
- Replace the rear oxygen sensor.
- Repair any oxygen sensor wires that have shorted out, are broken or exposed.
- Make necessary repairs to remedy the excessive fuel pressure.
- Replace engine coolant temperature sensor if it is necessary.
How do I fix code p0137?
Zitat von Youtube: If you have a leak around the corner get some exhaust putty to seal it. Up first get a sandpaper and a wet wipe to clean the leaking area for better application stir the paste well to activate. It.
What is 02 sensor circuit bank 1 sensor 2?
Bank 2 Sensor 1 is the first sensor closest to the engine. On Bank 2 means it is at the engine side with cylinders 2, 4, 6, 8, etc. Bank 2 Sensor 2 is the second sensor on the engine’s exhaust pipe, usually behind the catalytic converter. On Bank 2 means it is at the engine side with cylinders 2, 4, 6, 8, etc.
What does bank 2 sensor 2 do?
The O2 sensor 2 is the downstream O2 sensor and it measures the amount of oxygen in the exhaust gases leaving the catalytic converter (cat). OBD code P0158 is set when the O2 sensor 2 has been emitting a voltage signal above its normal range for a certain amount of time.
What does engine code P0158 mean?
When trouble code P0158 is set, this indicates that there is a high voltage (steadily above . 9 volts) for more than 10 seconds indicating a lack of oxygen in the exhaust stream and an abundance of fuel at sensor 2 on bank 2 of the engine.
What does diagnostic code P0158 mean?
Zitat von Youtube: If you are getting a p0158 error code this video is going to show you two practical solutions to fix the error code at home use the zeus app to scan your vehicle. And see the error code po158. It
What causes low voltage O2 sensor?
If you get this code, some of the possible causes include: Issues in the oxygen sensor or air-fuel ratio sensor. Defects in the circuit for the oxygen sensor or air-fuel ratio sensor heater. Vacuum leaks or a leak in the exhaust system.
How much does it cost to fix code P0137?
Depending on the shop’s labor rate, this typically costs somewhere between $75-$150. Many, if not most, shops will apply this diagnosis fee to any required repairs if you have them perform the repairs for you.
What causes a P0137 code?
What Does the P0137 Code Mean? Diagnostic trouble code (DTC) P0137 stands for “Oxygen Sensor Circuit Low Voltage (Bank 1, Sensor 2).” This error code is triggered by your car’s primary computer—often referred to as the powertrain control module (PCM)—when it perceives a problem with the oxygen (O2) sensor.
How do you know which O2 sensor is bad?
Zitat von Youtube: You can know for sure which of your o2 sensors is indicating a problem by having your code scanned. You can have your code scan for free at your local O'Reilly Auto Parts Store.
What side is bank 2 on a Chevy?
Bank 2 Locations
|Vehicle||Bank 2 Sensor 1 Location|
|Chevrolet Colorado||Passenger side with cylinder 2 in the firing order, in front of the catalytic converter|
|Ford Bronco||On the exhaust end, before the catalytic converter|
|Ford Ranger||Driver side, before the catalytic converter|
|GMC Sierra||Passenger side, before catalytic converter|