The P0339 code means that the car’s computer has detected a problem with the crankshaft position sensor A circuit. In this instance, it has detected a voltage reading that is higher than the maximum set by the manufacturer.
What can cause a P0339 code?
Code P0339 could be caused by any of the following issues: Faulty or damaged crankshaft position sensor (most common) Wiring issue between the crankshaft sensor and engine control unit, shorted or open circuit. Faulty connector to the crankshaft sensor, corrosion.
How do you fix a crankshaft position sensor on a circuit malfunction?
Zitat von Youtube: Position sensor is faulty and needs to be replaced. Check to make sure the o-ring from the sensor hasn't fallen into its hole then replace it with a new crankshaft.
What does crankshaft position sensor intermittent mean?
Diagnostic trouble code (DTC) P0339 stands for “Crankshaft Position Sensor “A” Circuit Intermittent. It indicates that the powertrain control module (PCM) has detected an irregular signal or failed to detect one from the crankshaft position sensor.
Where is the crankshaft speed sensor located?
Zitat von Youtube: Have a good look around the bottom of the engine on most modern cars the crankshaft sensor sits between the engine in the transmission. And it uses the flywheel as its reluctor.
How do I fix code P0339?
What repairs can fix the P0339 code?
- Repairing or replacing damaged wiring.
- Repairing loose connections.
- Repairing oil leaks responsible for degradation of wiring.
- Replacing a failed crankshaft position sensor.
- Replacing broken reluctor rings.
How do you reset a crankshaft position sensor?
Zitat von Youtube: Back on the scanner screen select crank pattern. Clear select continue once crank pattern clear is complete select crank pattern. Learning select continue the relearn is complete.
How much does it cost to replace a crankshaft sensor?
The average crankshaft sensor replacement cost is between $150 and $250. However, it’s not uncommon for those prices to skyrocket if you have a higher-end vehicle. That’s because the labor costs are typically between $90 and $110.
What can cause a crankshaft sensor code?
What causes the P0335 code?
- Open or short in the wiring harness.
- Poor electrical connections.
- Crankshaft position sensor failure.
- Damaged signal plate.
- Broken timing belt or chain.
- PCM faulty.
How much does a crank sensor cost?
The replacement cost of the crankshaft position sensor is anywhere from $120 to $300. The cost of the part itself will be around $75 to $120. The cost of the labor will be anywhere from $45 to $180. You need to factor in the estimated taxes and other fees that will be added to the total amount as well.
How do you test a crankshaft position sensor?
Zitat von Youtube: But you don't have to remove your sensor you can just do these tests on the car first things first you want to close you take a look at the plastic housing. Your sensor if you see any major cracks.
Can a crankshaft position sensor work intermittently?
Intermittent Stalling
Another symptom commonly associated with a problematic crankshaft position sensor is intermittent stalling. If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall.