P0341 is an OBD-II generic code that says the engine control module (ECM) detected the engine camshaft position sensor circuit is not within specifications. The sensor pulses do not correlate to the pulses of the crankshaft sensor.
How do I fix error code P0341?
Zitat von Youtube: Position sensor is faulty and needs to be replaced. Check to make sure the o-ring from the sensor hasn't fallen into its hole then replace it with a new camshaft. Position sensor.
Can I drive with a P0341 code?
Trouble code P0341 should be diagnosed and repaired as soon as possible. Not recommended, however, you may drive your vehicle while trouble code P0341 is present unless the engine stall or stumbling is is severe enough to hinder proper vehicle operation. Erratic engine speed may be noticed.
Can low oil cause a P0341 code?
I have also read that sometimes P0341 can also just be from low oil level. If the oil level is very low, not enough oil is present to feed the N205 allowing proper adjusting.
Where is the camshaft position sensor located?
The Camshaft Position sensor is typically located in the cylinder head of the engine and has a cylindrical portion that inserts into the head. The Crankshaft Position sensor is normally located in the timing cover or on the side of the block with a cylindrical portion that inserts into the block.
How do you fix a camshaft position sensor?
Zitat von Youtube: If it has repair the leak to prevent the new sensor from being damaged. Check to make sure the o-ring from the sensor hasn't fallen into its hole push. The new sensor into place and replace the bolt.
What is bank1 sensor B?
Bank 1 is the side of your engine that has the cylinder 1, while sensor B refers to the exhaust camshaft side. Some car manufacturers have their own description of the P0017 code, such as GM (more specifically, Chevrolet).
Is P0341 serious?
How serious is the P0341 code? A failed camshaft sensor can cause the engine to run erratic, stall, or not start at all. An intermittent camshaft sensor signal can cause the engine to run rough, jerk, or misfire while driving. The Check Engine Light on will cause the vehicle to fail emission testing.
What is camshaft position sensor A circuit Bank 1?
The camshaft position sensor calculates the speed at which the engine’s camshaft rotates. It also keeps track of the shaft’s precise position during rotation. It signals the PCM, which uses the sensor data to set the timing for the ignition and fuel injection systems.