P0347 is a diagnostic trouble code (DTC) for “Camshaft Position Sensor A Circuit Low Input (Bank 2)“. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
How do I fix code P0368?
Zitat von Youtube: Position sensor. The crankshaft is most often located on the front underside of the engine. It can usually be found mounted to the timing. Cover first carefully remove the crankshaft.
What does engine code P0368 mean?
What the P0368 code means. Your powertrain control module (PCM) has detected an incorrect voltage reading or waveform from your vehicle’s camshaft position sensor circuit for camshaft sensor “B” in engine bank one.
What does engine code P0365 mean?
What the P0365 code means. Essentially, the P0365 code means that there has been a lack of voltage detected from the camshaft position sensor B in bank 1 by the PCM within a few seconds of the engine starting.
What is the engine code P0390?
The P0390 code is stored if the powertrain control module (PCM) does not detect the camshaft position sensor signal within a few seconds of cranking. This code is specific to sensor “B,” which, in general, is the exhaust camshaft sensor.
How do I fix code P0014?
What repairs can fix the P0014 code?
- Replace camshaft timing control valve solenoid.
- Repair wirings to camshaft timing control valve solenoid.
- Clean oil lines to VCT or VVT system.
- Replace valve control unit (VVT or VCT, for example)
- Replace timing belt or timing chain.
- Replace camshaft position sensor.
How do I fix code P0369?
Typical avenues for fixing the problems related to P0369 are:
- Testing the battery.
- Repairing/replacing any disconnected, shorted, damaged, or corroded wires, connectors, or other components.
- Testing the camshaft for irregular ignition timing.
Where is camshaft position sensor a bank 1 located?
Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.
Where is the camshaft position sensor located?
The Camshaft Position sensor is typically located in the cylinder head of the engine and has a cylindrical portion that inserts into the head. The Crankshaft Position sensor is normally located in the timing cover or on the side of the block with a cylindrical portion that inserts into the block.