The P0406 code is the result of the exhaust gas circulation (EGR) sensor A having a high circuit voltage. This code is set when the ECM identifies the EGR voltage is higher than the specified range, thus triggering the check engine light to illuminate on the vehicle dashboard.
How do I fix error P0406?
What repairs can fix the P0406 code?
- Replacing the EGR valve.
- Repairing or replacing wiring harness as needed.
- Repairing poor electrical connections.
- Replacing the vacuum line.
- Cleaning excessive carbon buildup.
How do you fix an exhaust gas recirculation sensor A circuit high?
Zitat von Youtube: First carefully remove the egr valve from your car. Turn the egr valve upside down and fill it up with the wd-40. Cleaner. Let it soak for five hours for the solvent to get rid of all the carbon.
What causes EGR High Voltage?
Here are the possible reasons why the sensor is sending too high voltage signals to the PCM: Faulty EGR valve position sensor. Bad EGR valve. Circuit issues, such as damaged wires or poor connections.
Where is the EGR pressure sensor located?
Mechanical EGR valve position sensors are mounted on the top of the EGR valve. EGR pressure sensors will be located close to the EGR valve as the exhaust gas hose must be connected to the sensor as well as the valve.
How do you clean an EGR valve without removing it?
Zitat von Youtube: The air intake pipe that comes off the air box. Simply undo it take the can and then trade it in in small intervals.
How much is an EGR valve?
The average cost of replacing the EGR valve in your vehicle is anywhere from $250 to $350 on average, depending on your vehicle’s year, make, and model as well as the type of system it has. The cost of parts will be somewhere around $190 to $270, while the cost of labor will be anywhere from $60 to $80.
Where is the exhaust gas recirculation sensor?
The EGR temperature sensor is usually mounted in the exhaust manifold or mounted near the EGR valve.
How do you replace an exhaust gas recirculation valve?
Zitat von Youtube: Right here we just have to take the two bolts off and hold it in place so you get a wrench. And put it on the bolt. And take them both off then we unplug the vacuum line that comes out of the hole.
How do you clean an EGR valve?
Zitat von Youtube: So get some carburetor cleaner and spray it. In hey you can see I got all the black crud coming out of this thing it's filthy.
How do you test a EGR valve?
Zitat von Youtube: But really the best thing you can do is get yourself one of these vacuum testers now let me just reposition the camera here. Now we will test this valve in a running vehicle.
How do you check EGR voltage?
How to Test an Electric EGR Valve
- Turn the vehicle off and remove the key from the ignition. …
- Open the hood and locate the EGR valve. …
- Turn the multimeter on and set the dial to “Volts DC.” Attach the red lead wire to the EGR circuit labeled “C.” There are five circuits on the EGR and each is labeled A-E.