The P0463 code is triggered when your vehicle’s powertrain control module (PCM) detects inaccurate fuel level readings from the fuel level sensor. The fuel level sensor alerts the PCM of the amount of fuel in the fuel tank.
How do I fix error P0463?
Some of the most common fixes for a P0463 code include:
- Repairing or replacing the fuel tank.
- Repairing or replacing the fuel level sensor float.
- Repairing or replacing the fuel level sensor.
- Replacing the wiring harness for the fuel level sensor.
- Tightening a loose connection in the fuel level sensor circuit.
How do I reset my fuel level sensor?
Press and hold the “Trip/Odo” button. Turn the ignition switch on and hold the “Trip/Odo” switch for about two seconds. Then, release the “Trip/Odo” button, press it again (do this three or four times), and finally hold it for about four to five seconds until the leveling information shows on the Odometer.
What does fuel level sensor A circuit high mean?
Diagnostic trouble code (DTC) P0463 stands for “Fuel Level Sensor “A” Circuit High.” It means that there is an unusually high voltage signal coming from your vehicle’s fuel sensor. The result is that the fuel gauge will not read accurately.
How much does it cost to fix a fuel level sensor?
The average cost to replace a fuel gauge sender is between $800 and $1,000. The labor costs around $150 to $200, while the parts account for $650 and $800. These replacement costs vary based on what type of car you drive and how difficult the installation is.
Where is the fuel level sensor located?
The fuel gauge sender is located in the fuel tank and attached to the fuel pump. The sender has a base with a rod and float attached to it.
How do I reset my gas tank?
Zitat von Youtube: Turn off all gas appliances then remove the black cap. Grab hold of the plastic plunger. And pull forward this will reset the supply.