P0720 DODGE code

The P0720 code is a standard OBD-II trouble code that detects an issue with the output speed sensor circuit. The powertrain control module (PCM) relies on a signal from the output speed sensor, so that it can determine the correct shift strategy and send that information to the transmission.

What can cause a P0720 code?

What can cause the P0720 engine code?

  • Low or dirty transmission fluid.
  • Faulty output speed sensor or input speed sensor.
  • Wiring problems.
  • Bad powertrain control module PCM (rare)

Where is the output speed sensor circuit located?

The output shaft speed sensor is located nearest the drive axle, and is used by the ECU to monitor the speed/RPM of the transmission output shaft.

How do you fix an output speed sensor no signal?

Repairing or replacing a damaged or faulty shift solenoid. Flushing the system and changing the transmission fluid. Replacing a bad valve body. Replacing damaged or corroded wiring or connectors for the output speed sensor’s circuit.

What is a speed sensor circuit?

Located on or inside your vehicle’s transmission, the turbine speed sensor measures the RPM of the turbine shaft. Once the PCM or TCM detects an irregularity in the turbine speed input, it will trigger the illumination of the Check Engine Light.

How do I fix error code P0720?

What repairs can fix the P0720 code?

  1. Replacement of the output speed sensor.
  2. Replacement of the input speed sensor.
  3. Replacement of the wires or connectors.
  4. Drain and refill of the transmission fluid.
  5. Replacement of the PCM.

How much is it to fix a speed sensor?

The average cost for vehicle speed sensor replacement is between $256 and $301. Labor costs are estimated between $107 and $135 while parts are priced between $149 and $166. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

How do you test a transmission speed sensor?

Zitat von Youtube: Connector. So the red lead is hooked up. And then the black is ground ground is any good metal point so right here is perfect take a look at the multimeter.

What is P0725 code?

The P0725 code is a generic OBD-II trouble code that notes a problem with the engine speed input circuit. The engine input speed sensor is responsible for sending a signal about the engine’s speed to the powertrain control module (PCM).

What is the output speed sensor?

The vehicle speed sensor (VSS) is also commonly referred to as a transmission speed sensor or output shaft speed sensor. It is a small device—typically mounted somewhere on the transmission—that determines how fast your vehicle is going by measuring the rotation of a toothed wheel on a shaft inside the transmission.

What does P0722 mean?

Output Speed Sensor No Signal

OBD-II Code P0722 is defined as a Output Speed Sensor No Signal. When the code P0722 is set in the Powertrain Computer, it means that the Powertrain Computer or PCM is not seeing a consistent speed signal from the Transmission’s Output Speed Sensor.

What does Engine code P0715 mean?

Code P0715 is triggered when the Engine Control Module (ECM) or Transmission Control Module (TCM) detects an irregular signal coming from the input/turbine speed sensor in the transmission.