P0720 FORD code

If your vehicle is showing code P0720, this indicates a problem with your output speed sensor circuit. This means that your vehicle’s computer has sensed a problem with the sensor that helps it control the way the vehicle shifts gears.

How do I fix error code P0720?

What repairs can fix the P0720 code?

  1. Replacement of the output speed sensor.
  2. Replacement of the input speed sensor.
  3. Replacement of the wires or connectors.
  4. Drain and refill of the transmission fluid.
  5. Replacement of the PCM.

What can cause a P0720 code?

The P0720 code is activated when the PCM detects insufficient or erratic input from the output shaft sensor (OSS).

Where is the output speed sensor circuit located?

The output shaft speed sensor is located nearest the drive axle, and is used by the ECU to monitor the speed/RPM of the transmission output shaft.

How do you fix an output speed sensor no signal?

Repairing or replacing a damaged or faulty shift solenoid. Flushing the system and changing the transmission fluid. Replacing a bad valve body. Replacing damaged or corroded wiring or connectors for the output speed sensor’s circuit.

How much does it cost to fix a P0720?

How much will it cost to fix the problem? Costs vary depending upon the cause of the P0720 code. For example, draining and replacing transmission fluid professionally generally costs between $240-290. On the other hand, replacing an output speed sensor will likely cost somewhere between $330-380.

How much is it to fix a speed sensor?

The average cost for vehicle speed sensor replacement is between $256 and $301. Labor costs are estimated between $107 and $135 while parts are priced between $149 and $166. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

How do you fix a speed sensor on a car?

Zitat von Youtube: Well just pull this all on the way wiggle it and get off. And there's a sensor hiding down inside the engine right there I've unplugged the plug on the top of it.

What does an output shaft speed sensor do?

The vehicle speed sensor (VSS) is also commonly referred to as a transmission speed sensor or output shaft speed sensor. It is a small device—typically mounted somewhere on the transmission—that determines how fast your vehicle is going by measuring the rotation of a toothed wheel on a shaft inside the transmission.

What does automatic transmission speed sensor do?

A transmission speed sensor calculates the transmission gear ratio when in use. A car has two speed sensors: the ISS and the OSS, working together to show the transmission data to the car’s powertrain module. The ISS sensor monitors the input shaft’s speed.

How do you test a transmission speed sensor?

Zitat von Youtube: Connector. So the red lead is hooked up. And then the black is ground ground is any good metal point so right here is perfect take a look at the multimeter.

What is P0725 code?

The P0725 code is a generic OBD-II trouble code that notes a problem with the engine speed input circuit. The engine input speed sensor is responsible for sending a signal about the engine’s speed to the powertrain control module (PCM).