P0755 DODGE code

The P0755 code indicates that there is a problem with the transmission’s shift solenoid B. Note that this only applies to automatic transmissions. Your transmission has multiple shift solenoids that are used to manage fluid transfer and flow from one circuit to another in order to shift gears.

Where is the transmission shift solenoid located?

Transmission Shift Solenoid Location



The Transmission shift solenoids are located inside the valve body of your automatic transmission. They are integrated into the valve body, and on some car models, you can see them without removing the valve body, while on others, you have to remove the valve body to reach them.

How much is solenoid replacement in a transmission?

$200 to $500

The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700.

What is a shift solenoid B performance or stuck off?

This code triggers when the PCM detects the “B” shift solenoid circuit has a malfunction. But the code can also be triggered or associated with several other transmission-related problems such as the following: Low or dirty transmission fluid. Clogged transmission fluid filter.

What is a shift solenoid B malfunction?

Shift solenoids open and close valves in the valve body to allow transmission fluid to reach your clutches and bands for a smooth shift. A malfunctioning shift solenoid “B” can potentially interrupt this process and cause a variety of transmission problems, which can make your vehicle undrivable.

How do you reset a transmission solenoid?

Zitat von Youtube: Then you're holding your foot on the gas bottle for about another 10 to 15 seconds.

Can you replace a shift solenoid yourself?

Once it is determined that you have a failed transmission shift solenoid the only repair is to replace the faulty part. Replacing a transmission shift solenoid can be done by most any auto repair shop, automobile dealership service center or you can do-it-yourself “DIY”.

How do I know if my transmission control solenoid is bad?

You may discover that the transmission will not shift out of neutral, as the solenoid is not receiving the proper signals or opening enough to shift the transmission. The gear shifts may seem rough or erratic, leading to a shaky or rocky feeling in the vehicle when you attempt to shift gears, accelerate, or decelerate.

What happens when a transmission control solenoid goes bad?

If you’re experiencing transmission solenoid troubles, it will become evident in one of four ways: Delayed gear shifting. You can’t downshift, and your engine continues to rev even when applying the brakes. Your transmission gets stuck in neutral.

How do you check a transmission solenoid?

The testing of on/off solenoids is straightforward. Pressure should be applied to the inlet, and if it is normally closed, you should not see pressure at the outlet. Once energized, you should see pressure at the outlet. For a normally open solenoid, the opposite is true.

How do you fix a shift solenoid B malfunction?

The most common repair for the P0755 code is replacement of the shift solenoid circuit.



However, other repairs may include:

  1. Replacing a failed shift solenoid.
  2. Topping off low fluid.
  3. Changing burned, dirty fluid.
  4. Replacing or repairing a damaged wiring harness.


What does shift solenoid B Electrical mean?

What the P0758 code means. Shift solenoid B allows the transmission to shift between second and third gear. If the PCM records code P0758, it indicates that the PCM cannot see the proper change in engine RPMs or the correct increase in road speed that should be happening during a shift from second to third gear.