Code P0776 is an indication that your vehicle’s PCM has found an abnormality related to the electronic pressure control solenoid circuit or simply the solenoid itself.

How much does it cost to replace a pressure control solenoid B?

Depending on the make and model of your vehicle, expect to pay between $15 – $100 for a single transmission shift solenoid. A pack can cost $50 to $300.

Transmission Solenoid Replacement Cost – Parts & Labor.

Type Cost Range
Single $15 to $100
Pack $50 to $300
Labor $120 to $400
Total (Pack) $250 to $600

What causes P0776?

These pressure changes cause the transmission to change gear ratios at the correct timing. The P0776 is triggered by the PCM when the pressure control solenoid “B” is not functioning properly, or is stuck in the “off” position.

How do you replace a pressure control solenoid?

How to Replace a Pressure Control Solenoid Valve in a…

  1. Disconnect the battery. Remove the negative terminal with a socket set and wrench first, then remove the positive cable. …
  2. Pull the oil pan from the bottom of the transmission. …
  3. Unthread the bolts or screws on the fix plate and remove it.

What causes pressure control solenoid?

Here are this trouble code’s most common causes: Defective or faulty pressure control solenoid. Dirty transmission filter and/or fluid. Faulty transmission pump and/or valve body.

How do I fix error code P0776?

What repairs can fix the P0776 code?

  1. Repair/replace faulty electrical components.
  2. Replace/fill the transmission fluid.
  3. Replace the clutch (if it’s been damaged by low transmission fluid amounts)
  4. Replace the PCM (very rare)

Can you replace a shift solenoid yourself?

Once it is determined that you have a failed transmission shift solenoid the only repair is to replace the faulty part. Replacing a transmission shift solenoid can be done by most any auto repair shop, automobile dealership service center or you can do-it-yourself “DIY”.

How much is a pressure control solenoid?

The replacement will cost you about $60-$140 for one hour. Generally, it cost you $150-$400 to get your vehicle inspected and the system replaced on the diagnosis of any fault. Single solenoids are around $15-$100 to buy. The entire pack will be a bit more expensive and range between $50-$300.

What is a solenoid B?

Shift solenoids open and close valves in the valve body to allow transmission fluid to reach your clutches and bands for a smooth shift. A malfunctioning shift solenoid “B” can potentially interrupt this process and cause a variety of transmission problems, which can make your vehicle undrivable.

How do you test a transmission control solenoid?

Zitat von Youtube: We're just going to go to ohms. And then you're just going to do a resistance test of each solenoid. So there's 10 point 9 ohms.

How much does it cost to replace a transmission solenoid?

$200 to $500

The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700.

Where is the automatic transmission control solenoid located?

Transmission Shift Solenoid Location

The Transmission shift solenoids are located inside the valve body of your automatic transmission. They are integrated into the valve body, and on some car models, you can see them without removing the valve body, while on others, you have to remove the valve body to reach them.