What does P1120 mean?
What Does Code P1120 Mean? OBD II fault code P1120 is a manufacturer specific code that is defined by car maker Ford as “Throttle Position Sensor Out of Range”, and is set when the PCM (Powertrain Control Module) detects that the actual position of the throttle plate does not match the desired position.
What is code P1121 mean?
OBDII code P1121 is Throttle Position Sensor Circuit Intermittent High Voltage. If you have changed it recently it could be out of adjustment or faulty.
What is code P0122?
Code P0122 is triggered when your vehicle’s Engine Control Module (ECM) detects that your Throttle Position Sensor (TPS) circuit A is reporting an output voltage that is below its expected voltage. Depending on your vehicle, your TPS lower output voltage limit should be around .
What is Engine code P1125?
P1125 – Accelerator Pedal Position Sensor Fault (GM)
What is P1130 code?
OBD II fault code P1130 is a manufacturer specific code that is defined by carmaker Toyota and by extension, Lexus, as “Air/Fuel Ratio Sensor Circuit Range/Performance Malfunction Bank 1 Sensor 1.
How do I fix error code P1121?
The fix is replacing the valve. It’s mounted along the driver’s side frame of the engine compartment, near the radiator, and can be removed by elevating the inverter and pulling the valve out from the top.
What is a coolant flow control valve?
Excellent coolant flow control
Coolant switch valves control the coolant flow in side-flow cooling circuits of the powertrain and in the heating circuits of passenger compartments. In hybrid and electric vehicles, they can be used for coolant flow distribution, e.g. for cooling the battery and power electronics.
How do I fix code P0223?
What repairs can fix the P0223 code?
- Replacing the throttle position sensor.
- Replacing the Engine Control Module.
- Plugging in, repairing, or replacing wiring that is associated with the throttle position sensor.
- Repairing or replacing the throttle body.
- Realigning the throttle position sensor.
How do you reset throttle position sensor?
With the vehicle off, turn the key to the “on” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.
What causes low TPS voltage?
The voltage of the throttle position sensor can drop below the expected range for several reasons, including the following: A loosely-mounted throttle position sensor. Electrical short on the sensor circuit, either to the ground or to another wire. Faulty sensor.