P1153 FORD code

How do I fix code p1153?


Zitat von Youtube: Stop driving and repair your vehicle immediately it means that the pcm determines that the front heated oxygen sensor was unable to switch enough.

How do I fix code P0151?

What repairs can fix the P0151 code?

  1. Replacing the O2 sensor for bank 2 sensor 1 if all tests indicate a failed sensor.
  2. Repairing or replacing the wiring or connection to the O2 sensor for bank 2 sensor 1.
  3. Repairing exhaust leaks before the sensor that introduce excessive oxygen into the exhaust.


What causes P1133?

The Chevy P1133 trouble code is set when the Powertrain Control Module (PCM) detects a lack of switching from the upstream oxygen sensor in Bank 1, in front of the catalytic converter. This trouble code will illuminate the Check Engine Light, and may cause poor fuel economy and/or engine performance.

What is code P1133?

OBD II fault code P1133 is a manufacturer specific code, and on some applications, this code is defined as “HO2S (Heated Oxygen Sensor) Insufficient Switching Sensor 1”, and is set when the PCM (Powertrain Control Module) detects an insufficient number of switching cycles between a rich running and a lean running …

Which side is Bank 2 sensor1?

Bank 2 Sensor 1 (a.k.a. B2S1) is located on the side of the engine with cylinder 2 in the firing order and the O2 sensor situated in front of the catalytic converter. Depending on the car’s make and driver orientation, it could be found on either the driver or passenger side of a vehicle.

What is heated oxygen sensor?

OBD II equipped vehicles use heated oxygen sensors. Heated oxygen sensors have an internal heater circuit that brings the sensor up to operating temperature more quickly than an unheated sensor.

What can cause a P0151?

What are the Possible Causes of Code P0151?

  • A faulty front O2 sensor (bank 2)
  • An issue with the O2 sensor’s circuit.
  • A lean running condition.
  • An exhaust leak.


Is bank 2 sensor 1 upstream or downstream?

Bank 1 Sensor 1 means Upstream Right/Rear;Bank 2 Sensor 1 means Upstream Left/Front;Bank 1 Sensor 2 means Downstream Right/Rear;Bank 2 Sensor 2 means Downstream Left/Front.

What does bank 2 System too lean mean?

Zitat von Youtube: It means that the fuel. Parts are too few or the air parts are too many.

How do I fix code p0137?

Zitat von Youtube: If you have a leak around the corner get some exhaust putty to seal it. Up first get a sandpaper and a wet wipe to clean the leaking area for better application stir the paste well to activate. It.

What is P1130 code?

OBD II fault code P1130 is a manufacturer specific code that is defined by carmaker Toyota and by extension, Lexus, as “Air/Fuel Ratio Sensor Circuit Range/Performance Malfunction Bank 1 Sensor 1.