P2008 means that the intake manifold runner circuit has an open electrical connection bank 1. The ECU tries to control the the angle of the intake manifold runner flappers and when it cannot control this circuit sets a Check Engine Light.
Where is the intake manifold runner control located?
Step 2: Locate the IMRC.
Often, it’s bolted directly to the top of the intake manifold or at one end or the other. Sometimes it is bolted in a remote location, like the valve cover, and will use a cable connection to the intake flaps.
What does the intake manifold runner control valve do?
the intake manifold runner control system improves the engine airflow process, which helps performance and efficiency. although each carmaker’s design is different, the basic concept involves opening and closing butterfly valves within the intake manifold. the valves divert airflow, changing the length of the runners.
How do I fix code P2004?
What repairs can fix the P2004 code?
- Replacing the IMRC solenoid.
- Repairing or replacing IMRC solenoid wiring that has shorts, breaks or is frayed.
- Repairing or replacing IMRC solenoid circuitry that has shorted or is open.
- Repairing or replacing IMRC solenoid connector that is corroded.
What is code P2017?
P2017 is a diagnostic trouble code (DTC) for “Intake Manifold Runner Position Sensor/Switch Circuit High Bank1“. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
How do I fix code P2008?
What repairs can fix the P2008 code?
- Intake manifold runner flaps unstuck.
- Wiring harness replaced or repaired as needed.
- Intake manifold runner control solenoid replacement.
- Repair of poor electrical connection.
How much does it cost to replace a intake manifold runner control?
A new intake manifold runner valve can cost anywhere between $50 and $200, depending on factors like its brand and your vehicle’s specifications. Labor costs for replacing a damaged intake manifold runner valve typically range from $300 to $400.
What causes P2004 code?
If you get an OBD-II scanner error code P2004 problem that means the intake manifold runner control actuator is stuck in the open position.
How do I replace intake manifold runner control?
How to replace an intake manifold runner control
- Extract the engine trim cover from the engine.
- Remove the faulty intake manifold runner control.
- Install the new intake manifold runner control.
- Reinstall the engine trim covers.
- Examine the engine to ensure the safety of the new equipment.