P2014 is an OBD-II powertrain code for a voltage issue with the intake manifold runner control system in that the runner flaps that allow the flow of air don’t open according to the manufacturer’s parameters. The bank 1 relates to the bank of cylinders where cylinder one is present.
What is intake manifold runner control actuator?
The Intake Manifold Runner Control (IMRC) is an electrically actuated system consisting of a motorized actuator with an attaching linkage for each housing on each bank. The linkage attaches to the housing butterfly plate levers. Each IMRC housing is an aluminum casting with two intake air passages for each cylinder.
How do I fix code P2017?
What repairs can fix the P2017 code?
- Replacing a faulty intake manifold control solenoid.
- Thoroughly cleaning the intake manifold.
- Cleaning the mass airflow sensor.
- Repairing damaged wiring related to the circuit of the intake manifold runner.
- Repairing an open or short related to the circuit of the intake manifold runner.
How much does it cost to fix P2006 code?
between $400 and $600
How much will it cost to fix? If you need to repair or replace your intake manifold runner, total parts and labor can cost anywhere between $400 and $600.
What causes P2015 code?
Diagnostic Trouble Code (DTC) P2015 stands for “Intake Manifold Runner Position Sensor /Switch Range/Performance (Bank 1).” This code simply indicates that the powertrain control module (PCM) has detected that the signal in the Bank 1 intake manifold runner position sensor is out of range.
What can a bad intake manifold runner control cause?
If the intake manifold runner control has an issue it can cause the vehicle to experience engine performance issues such as misfires, a decrease in power and acceleration, a decrease in fuel efficiency, and even stalling.
How much does it cost to replace a intake manifold runner control?
A new intake manifold runner valve can cost anywhere between $50 and $200, depending on factors like its brand and your vehicle’s specifications. Labor costs for replacing a damaged intake manifold runner valve typically range from $300 to $400.
How do you clean an intake manifold without removing it?
Zitat von Youtube: Allow the engine to run at a fast idle and spray about half of the can into the vacuum. Line. Once this is done turn off the engine. And leave the spray to soak in for five minutes.
What is intake manifold runner control stuck open?
Essentially, this is the part that controls how fuel gets pumped into the part of the engine that combusts fuel to produce power. This system is controlled by the powertrain control module, which means if the actuator is stuck open, it might be a problem with either the intake manifold or the powertrain control module.
What is P2017 code?
What Does the P2017 Code Mean? P2017 is the diagnostic trouble code for “Intake Manifold Runner Position Sensor / Switch Circuit High Bank 1.” It typically applies to modern vehicles that have fuel-injected engines.
What causes P2006?
What the P2006 code means. The P2006 code means that the intake manifold runner control circuit has detected a stuck closed intake runner flap for bank 1. The ECU tries to control the the intake manifold runner flap position, when the malfunction is detected a Check Engine Light is set.
Can P2006 cause misfire?
Since a misfire can cause incoming fuel/air the ignite in the intake manifold you may be getting the P2006 code due to the pressure the igniting fuel is putting on the tumble flaps. In other words, cure the misfire and you may cure the tumble flap code.