What the P2016 code means. P2016 is an OBD-II generic code for the Engine Control Module (ECM) detecting a low voltage failure in the intake manifold runner position sensor/switch circuit, causing the ECM to turn on the Check Engine Light and set the P2016 code.
How much does it cost to replace a intake manifold runner control?
A new intake manifold runner valve can cost anywhere between $50 and $200, depending on factors like its brand and your vehicle’s specifications. Labor costs for replacing a damaged intake manifold runner valve typically range from $300 to $400.
What is code P2016?
Code P2016 stands for “Intake Manifold Runner Position Sensor/Switch Circuit Low Bank 1.” It’s a generic powertrain code that applies to many newer vehicles. A P2016 code might mean that your powertrain control module (PCM) has detected a problem with Bank 1 of your engine’s cylinders.
What is code P2017?
P2017 is a diagnostic trouble code (DTC) for “Intake Manifold Runner Position Sensor/Switch Circuit High Bank1“. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What is P2015 code?
Code P2015 indicates the PCM has detected the bank 1 intake manifold runner position sensor signal is out of range. Bank 1 refers to the side of the engine with the #1 cylinder, whereas bank 2 refers to the side of the engine with the #2 cylinder.
How long does it take to replace the intake manifold?
In most cases, it takes two to four hours for the entire process to be complete. Removing the old intake manifold only takes about 40 minutes, but installing the new one and reassembling takes much longer.
How much is labor for intake manifold?
The Best in Auto Repair
The average cost for intake manifold gasket replacement is between $555 and $614. Labor costs are estimated between $217 and $273 while parts are priced between $338 and $340.
How do I fix code P2016?
What repairs can fix the P2016 code?
- Replacing the intake manifold runner sensor for bank 1.
- Repairing the wiring harness or connector to the sensor.
- Replacing the ECM for an internal faulty circuit.
How do I fix code P2004?
What repairs can fix the P2004 code?
- Replacing the IMRC solenoid.
- Repairing or replacing IMRC solenoid wiring that has shorts, breaks or is frayed.
- Repairing or replacing IMRC solenoid circuitry that has shorted or is open.
- Repairing or replacing IMRC solenoid connector that is corroded.
Where is the intake manifold runner position sensor Bank 1?
Bank 1 sits on the side of the engine where the #1 cylinder is located. Bank 2 refers to the side of the engine with the #2 cylinder. However, inline engines only have one bank.
What is a intake manifold runner valve?
The intake manifold runner control is an engine management component that is found on newer intake manifold designs. It is usually a motorized or vacuum actuated unit attached to the intake manifold, that controls the opening and closing of butterfly valves inside of the intake manifold runners.