P2088 GMC code

The P2088 error code is generally known as the “A” camshaft position actuator control circuit low bank 1. Newer vehicles will be utilizing a variable timing system so that the timing of the camshaft can be adjusted in relation to the crankshaft so as to raise the performance and the efficiency of the fuel.

What is code P2088?

OBD-II Code P2088 is defined as a “A” Camshaft Position Actuator Control Circuit Low. Newer vehicle’s use a variable timing system to adjust the timing of the camshaft in relation to the crankshaft to increase fuel efficiency and performance.

What is intake camshaft position actuator?

The intake camshaft actuator features a gray electrical plug and is located closer to the front of the vehicle on the top of the cylinder head. When your factory intake actuator begins to fail your car’s computer may trigger fault codes P0010 or P011 resulting in a check engine light.

What is P0010 code?

P0010 is a generic OBD-II code indicating an issue with the engine control module (ECM) detecting a variation in the mechanical timing between the crankshaft and bank 1 camshaft. The timing issue is typically detected during higher RPMs of the engine when the ECM attempts to adjust valve lift during higher speeds.

How do I fix code P2088?

How To Correct P2088 A Camshaft Position Actuator Control Circuit Low Bank 1

  1. The variable camshaft timing solenoid has to be changed.
  2. The damaged wires need fixation.
  3. The variable time actuator must be changed.
  4. If possible, the blown fuse or fuse-able link must be altered.
  5. Corrosion from the connector must be cleaned.

How do I fix P0245 code?

What repairs can fix the P0245 code?

  1. The wastegate solenoid A is replaced for a short internally.
  2. The wiring connections to the solenoid are cleaned or replaced due to corrosion in the connections.
  3. The wiring harness is repaired and repositioned for shorted or melted wires.

How much does it cost to replace a camshaft adjuster solenoid?

Camshaft Solenoid Replacement Cost By Repair Shop

Type Of Service Work Price
Midas Parts & Labor $200-$702
Mr.Tire Parts & Labor $180-$700
NAPA Parts & Labor $220-$750
Walmart Parts $150-$419

How do you test a camshaft actuator?

Zitat von Youtube: On both sides. And then i mark. Now i mark any of my electrical connectors when i remove. This is overkill on this engine. Because they can't be interchanged. The exhaust one is black the intake.

Where is the camshaft solenoid located?

The Camshaft Position sensor is typically located in the cylinder head of the engine and has a cylindrical portion that inserts into the head. The Crankshaft Position sensor is normally located in the timing cover or on the side of the block with a cylindrical portion that inserts into the block.

Is it safe to drive with a P0010 code?

Is It Safe To Drive With A P0010 Code? The Moderate classification applies to alcohol. No problem can prevent you from running your vehicle when you have this trouble code. Your vehicle could experience decreased fuel economy and power if this code isn’t solved.

How much does it cost to fix code P0010?

Electrical or wiring problems are usually related to age and should be affordable to fix ($100). But if the P0010 code is caused by damage to major engine components like stretched timing chains or bad tensioners, the cost of fixing the problem can easily reach $300 to $500 for parts and labor.