P2093 is a diagnostic trouble code (DTC) for “A Camshaft Position Actuator Control Circuit High Bank 2“. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What is the code for a camshaft actuator?
What Does the P0010 Code Mean? Code P0010 stands for “A” Camshaft Position Actuator Circuit (Bank 1). The code indicates that your car’s primary computer, which is also referred to as the powertrain control module (PCM), perceives a problem with one of the engine’s VVT solenoids.
What does P000C code mean?
The OBD error code P000C indicates that your vehicle has a problem with the performance of its engine and the fuel efficiency. This means that the powertrain control module (PCM) which controls the oil control valves has detected a fault with the position and timing of the camshaft.
What does code p020 mean?
What the P0020 code means. P0020 is the OBD-II generic code indicating that the engine control module (ECM) has determined that the bank 2 intake camshaft Oil Control Valve (OCV) has an open or short circuit.
Where is the camshaft actuator located?
The intake camshaft actuator features a gray electrical plug and is located closer to the front of the vehicle on the top of the cylinder head.
What does a camshaft actuator do?
The movement of the exhaust camshafts will retard the exhaust valve timing. When oil pressure is applied to the return side of the vanes, the camshafts will return to 0 crankshaft degrees, or top dead center (TDC). The CMP actuator solenoid valve directs the oil flow that controls the camshaft movement.
How do I fix code P0018?
What repairs can fix the P0018 code?
- Repair or replace the wiring to the camshaft sensor on bank 2.
- Repair the wiring or connection to the camshaft OCV.
- Replace the camshaft OCV or the camshaft sensor for bank 2 camshaft.
What does code P000A mean?
Camshaft Position Slow Response
OBD-II Code P000A is defined as a “A” Camshaft Position Slow Response. The engine control module (PCM) uses a signal from the camshaft position sensor to determine the proper time to fire the fuel injector and ignite the spark plug.
What does the code P0019 mean?
What Does Code P0019 Mean? P0019 definition: The correlation of the camshaft and crankshaft positions on bank 2 is incorrect based on the intake camshaft position sensor. Issue Severity: SEVERE – Stop driving immediately. Repair Urgency: Fix this code immediately (same day if possible) to avoid internal engine damage.
How do I fix code P0022?
What repairs can fix the P0022 code?
- Resetting the fault codes and performing a road test.
- Replacing the oil and filter using the proper oil viscosity for the engine.
- Repairing or replacing the wiring or connection to the camshaft oil control valve (OCV)
How do I fix the timing on my camshaft position?
Zitat von Youtube: Use a valve cleaner to clean the camshaft oil control valve. Then use a multimeter to proceed a test on the camshaft.