The diagnostic trouble code (DTC) P2101 means that your car’s powertrain control module (PCM) has detected a discrepancy between where the throttle is positioned and where it should be positioned.
How do I fix error code P2101?
What repairs can fix the P2101 code?
- Replacing the TAC assembly if it fails all pinpoint tests and problem has been verified.
- Repairing the wiring or connection to the TAC assembly.
- Replacing the ECM as directed by the pinpoint test.
What causes a P2101 code?
Diagnostic Trouble Code (DTC) P2101 stands for Throttle Actuator “A” Control Motor Circuit Range/Performance. It is usually triggered when your vehicle’s powertrain control module (PCM) detects that the actual throttle position does not match the desired throttle position.
How do you fix a throttle actuator control system?
What repairs can fix the P2111 code?
- Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
- Clean the throttle body. …
- Replace the throttle body. …
- Replacing the PCM. ( …
- Repair the wiring.
What is a throttle actuator control motor?
The throttle actuator control motor is used on cars with electronically controlled throttle bodies also called drive-by-wire. On these systems, the gas pedal is a sensor that sends a signal to the throttle actuator control motor which opens and closes the throttle plate according to demand.
Can I drive with P2101 code?
How serious is the P2101 engine code? The P2101 engine code is a serious one and you should have it immediately serviced. Your car will be difficult to drive if it’s stuck in a prolonged limp mode or is unable to accelerate.
How much does it cost to replace a throttle actuator control system?
The throttle body part will typically cost between $200 and $500, depending on the type of car that you drive. Labor costs for this kind of repair are typically relatively low, so you can expect to pay between $50 and $150 to have the part professionally installed.
How do I clean my throttle body?
Zitat von Youtube: Go ahead and relieve the pressure remove. It and then just let it close nice and gentle notice we've still got a little bit of debris on this side of the throttle plate.
Where is the TAC module located?
The TAC module is mounted on the driver’s side firewall under the corner brace. There are 2 connectors plugged into the bottom of it, one 10 pin and one 16 pin.
What is the throttle body?
A throttle body is a butterfly valve located between the air intake filter and the intake manifold. It regulates how much air can go into the engine, based on driver input through the gas pedal. As more air flows into the engine, it injects more fuel, thus allowing for more power.
How do you reset the throttle position sensor on a Ford?
Resetting the throttle position sensor is a simple process that can be done in just a few minutes.
- Find The Throttle Position Sensor. …
- Disconnect The Electrical Connector. …
- Unhook The Negative Cable From The Battery. …
- Remove the Screws. …
- Reconnect The Battery and Start The Engine. …
- Regularly clean the throttle body and sensor.
Where is throttle actuator control located?
The throttle controller is located on top of the engine between the air intake and the intake manifold.