Learn More About OBD Error Code P2108. The Throttle Actuator Control System is controlled by the PCM by monitoring one or more throttle position sensors. According to the position of the throttle plate that is controlled by the Throttle Actuator Control Motors, the operation of the throttle body is determined.
How do I fix error code P2108?
What repairs can fix the P2108 code?
- Replacing the throttle position sensor or its circuitry.
- Replacing the throttle body motor or entire throttle body depending on the build style.
- Replacing the throttle control module or powertrain control module.
How do you fix a throttle actuator control system?
What repairs can fix the P2111 code?
- Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
- Clean the throttle body. …
- Replace the throttle body. …
- Replacing the PCM. ( …
- Repair the wiring.
What does engine code P2108 mean?
Zitat von Youtube: P2108 is a diagnostic trouble code for throttle actuator circuit control module. Performance. Under this circumstance stop driving and repair your vehicle immediately. It means there is a malfunction
Where is the TAC module located?
The TAC module is mounted on the driver’s side firewall under the corner brace. There are 2 connectors plugged into the bottom of it, one 10 pin and one 16 pin.
What is a throttle valve actuator?
A Throttle Kicker Actuator is a component of the throttle control which helps to regulate throttle control in situations where additional throttle is needed suddenly or when there is a sudden drop in throttle needed.
What is the throttle body?
A throttle body is a butterfly valve located between the air intake filter and the intake manifold. It regulates how much air can go into the engine, based on driver input through the gas pedal. As more air flows into the engine, it injects more fuel, thus allowing for more power.
Where is throttle actuator control located?
The throttle controller is located on top of the engine between the air intake and the intake manifold.
How much does it cost to replace a throttle actuator control system?
The throttle body part will typically cost between $200 and $500, depending on the type of car that you drive. Labor costs for this kind of repair are typically relatively low, so you can expect to pay between $50 and $150 to have the part professionally installed.
How do I clean my throttle actuator control?
Zitat von Youtube: Remember pull the tab. Push. It in to the component. And then remove it the throttle body itself is held in with four bolts for this.
How do I fix code U0107?
How to diagnose and repair U0107
- Perform a preliminary inspection. Sometimes U0107 can pop up intermittently, or it can result from a dead battery. …
- Check the battery. Like any other module, the TAC needs proper battery voltage to operate. …
- Check for other DTCs. …
- Check for a faulty control module.
How do I fix error code P2172?
What repairs can fix the P2172 code?
- Replacing the throttle body.
- Replacing the MAP sensor.
- Repairing a vacuum leak.
- Resolving an open or short in the wiring harness.
- Getting a sticking throttle body unstuck.