What the P2108 code means. This trouble code indicates that the powertrain control module has detected a malfunction with the throttle body control motor or module. This code is only found on vehicles that have an electronic throttle body.
How do you fix a throttle actuator control system?
What repairs can fix the P2111 code?
- Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
- Clean the throttle body. …
- Replace the throttle body. …
- Replacing the PCM. ( …
- Repair the wiring.
Where is the TAC module located?
The TAC module is mounted on the driver’s side firewall under the corner brace. There are 2 connectors plugged into the bottom of it, one 10 pin and one 16 pin.
How do I fix code U0107?
How to diagnose and repair U0107
- Perform a preliminary inspection. Sometimes U0107 can pop up intermittently, or it can result from a dead battery. …
- Check the battery. Like any other module, the TAC needs proper battery voltage to operate. …
- Check for other DTCs. …
- Check for a faulty control module.
What is a throttle actuator control module?
Product Description. An ACDelco GM Original Equipment Fuel Injection Throttle Control Actuator Module is an electrically operated motor assembly that controls the throttle plate(s), and is a GM-recommended replacement for your vehicle’s original component.
Where is throttle actuator control located?
The throttle controller is located on top of the engine between the air intake and the intake manifold.
How much does it cost to replace a throttle actuator control system?
The average cost for throttle body replacement is between $489 and $600. Labor costs are estimated between $86 and $109 while parts are priced between $403 and $491. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
How do you test a throttle actuator control module?
Zitat von Youtube: Between terminals a and b of the throttle actuator motor. If the throttle actuator motor is okay the resistance value should be around 2 to 15 ohms.
What is code P2118 mean?
throttle actuator control motor current / performance
The P2118 code is a general OBD-II diagnostic trouble code (DTC) that is referencing the throttle actuator control motor current / performance. This code may be seen with other throttle position sensor codes.
How do I fix error code P2101?
What repairs can fix the P2101 code?
- Replacing the TAC assembly if it fails all pinpoint tests and problem has been verified.
- Repairing the wiring or connection to the TAC assembly.
- Replacing the ECM as directed by the pinpoint test.
What causes lost communication with body control module?
Circuit problems, such as a damaged wire or poor connection. BCM internal hardware failure or software in need of an update. Data network problems. Depleted battery.
What causes code P2138?
Diagnostic trouble code (DTC) P2138 stands for “Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation.” It is triggered when the vehicle’s engine control module (ECM) or powertrain control module (PCM) detects that the signals from the two throttle position sensors (or two accelerator pedal position sensors) do …