P2111 DODGE code

P2111 is a diagnostic trouble code (DTC) for “Throttle Actuator Control System – Stuck Open“. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

What does P2111 mean?

Throttle Actuator Control System – Stuck Open

OBD-II Code P2111 is defined as a Throttle Actuator Control System – Stuck Open. The throttle motor opens and closes the throttle plate, allowing more or less air to flow through the engine based on the driver’s request for power.

How do I fix my electronic throttle control?

Zitat von Youtube: Get a new one don't get a Rheem and the reman ones aren't that good the new ones are much better then you put a new gasket. In slide the throttle assembly over it. And then bolt it back on snog.

What causes throttle actuator control?

Zitat von Youtube: The throttle actuator control replaces. The need for mechanical linkage between the throttle body and the accelerator pedal.

Where is throttle actuator located?

The throttle body is located between the air cleaner and the intake manifold of the engine. Most throttle bodies are made of aluminum. The throttle body is connected to the gas pedal of your vehicle with a linkage or flexible cable, which moves the throttle shaft when the gas pedal is depressed.

How do I fix error code P2111?

What repairs can fix the P2111 code?

  1. Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
  2. Clean the throttle body. …
  3. Replace the throttle body. …
  4. Replacing the PCM. ( …
  5. Repair the wiring.


How do you test a throttle actuator?

Zitat von Youtube: And i'm placing the multimeter in ohms mode. And i'm getting a resistance reading of 3 ohms. And this resistance value lets me know that the throttle actuator motor is ok in this throttle body unit.

How do you reset a Dodge throttle body?

Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.

How much does it cost to fix electronic throttle control?

$300 to $1,500

If it’s the electronic throttle controller then the replacement cost can range from $300 to $1,500 depending on the location and time to complete the job. If it’s the throttle body itself that is damaged and needs to be replaced, the costs can also be in the same neighborhood.

How do you reset a throttle position sensor?

The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.

What is a throttle actuator?

A Throttle Kicker Actuator is a component of the throttle control which helps to regulate throttle control in situations where additional throttle is needed suddenly or when there is a sudden drop in throttle needed.

How do I clean my throttle body?

Zitat von Youtube: Go ahead and relieve the pressure remove. It and then just let it close nice and gentle notice we've still got a little bit of debris on this side of the throttle plate.