When the engine control module (ECM) detects out-of-range voltage or poor performance from the throttle actuator control motor, the P2118 code is set along with a Check Engine Light on the dashboard. When the P2118 code is set, it also triggers a failsafe mode to prevent damage to the vehicle.
What does P2118 mean?
Diagnostic trouble code (DTC) P2118 stands for “Throttle Actuator Control Motor Current Range/Performance.” The PCM controls the ETC system by monitoring its throttle position sensors. These sensors provide throttle angle feedback to the vehicle’s computer.
How do you fix a throttle actuator control system?
What repairs can fix the P2111 code?
- Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
- Clean the throttle body. …
- Replace the throttle body. …
- Replacing the PCM. ( …
- Repair the wiring.
What causes throttle actuator control?
Zitat von Youtube: The throttle actuator control replaces. The need for mechanical linkage between the throttle body and the accelerator pedal.
Where is throttle actuator located?
The throttle body is located between the air cleaner and the intake manifold of the engine. Most throttle bodies are made of aluminum. The throttle body is connected to the gas pedal of your vehicle with a linkage or flexible cable, which moves the throttle shaft when the gas pedal is depressed.
What causes P2118 code?
These are the most common causes of the P2118 code: Throttle actuator control motor failure. Failed pedal position sensor. Throttle position sensor faulty.
How much does a throttle actuator cost?
The throttle body part will typically cost between $200 and $500, depending on the type of car that you drive. Labor costs for this kind of repair are typically relatively low, so you can expect to pay between $50 and $150 to have the part professionally installed.
Where is the throttle actuator control module?
The TAC module is mounted on the driver’s side firewall under the corner brace. There are 2 connectors plugged into the bottom of it, one 10 pin and one 16 pin.
How do I clean my throttle actuator control?
Zitat von Youtube: Remember pull the tab. Push. It in to the component. And then remove it the throttle body itself is held in with four bolts for this.
How do you test a throttle body actuator?
Zitat von Youtube: Between terminals a and b of the throttle actuator motor. If the throttle actuator motor is okay the resistance value should be around 2 to 15 ohms.
What is a throttle actuator?
A Throttle Kicker Actuator is a component of the throttle control which helps to regulate throttle control in situations where additional throttle is needed suddenly or when there is a sudden drop in throttle needed.
How do I fix error code P2106?
How To Correct P2106 Throttle Actuator Control System – Forced Limited Power
- Throttle position sensor replacement.
- Accelerator pedal sensor replacement.
- Throttle control system reprogramming.
- PCM repair and reprogramming.
- Faulty wiring and connector replacement.