The OBD-II error P2132 is set by the Powertrain Control Module, when it notices an issue with the throttle position sensor. This code is hence defined as a Throttle/Pedal Position Sensor/Switch “F” Circuit Low.
What causes a P0229 code?
Code P0229 is caused by erratic or intermittent signals from the sensor to the ECM. These signals are still within the specified range of the sensor when the signal is being received by the ECM.
How do I fix error code P2122?
What repairs can fix the P2122 code?
- Replacing or repositioning a ground wire.
- Replacing the wiring and/or connectors in the CAN bus harness or throttle actuator motor.
- Replacing the throttle position sensor, the throttle actuator control motor, the throttle position actuator, or the pedal position sensor.
What is P2135 diagnostic code?
When code P2135 is set, the ECM has found that the throttle position sensor and accelerator pedal position sensor aren’t producing the expected signals that they should be. When the ECM detects this, it may put the vehicle in a fail-safe condition that limits throttle opening to 5-15%.
How do I fix error code P0299?
What repairs can fix the P0299 code?
- Turbo or supercharger replacement.
- Repairing of the intake system.
- EGR replacement.
- Boost pressure sensor replacement.
- Low engine oil pressure repair.
How much does it cost to fix P0299?
It really depends on the severity of the issue. Here’s a quick reference: Replace Turbocharger – $1,500+ Air intake hose – $100 to $300.
How do you reset the accelerator pedal position sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
How do you reset a throttle body?
Leave the key off for a moment, turn the key to the “On” position again, wait 3 seconds, and press the accelerator 5 times in 5 seconds. Wait 7 seconds, and hold the accelerator down. The check engine light should start blinking, continue to hold pedal down until it stops blinking. You can then start the car.