When code P2135 is set, the ECM has found that the throttle position sensor and accelerator pedal position sensor aren’t producing the expected signals that they should be. When the ECM detects this, it may put the vehicle in a fail-safe condition that limits throttle opening to 5-15%.
How do I fix error code P2135?
What repairs can fix the P2135 code?
- Replacing one or both throttle position sensors.
- Replacing the accelerator pedal position sensor.
- Repairing a fault in a circuit (throttle position sensor circuit, accelerator pedal position sensor circuit) such as open, short, corroded wiring, or poor connection.
Can you drive with a P2135 code?
Is It okay to Drive with? P2135 can cause stalling out, so you should avoid driving with it.
How much does it cost to fix P2135?
Because there are multiple possible causes of this engine code, the repair cost will really vary depending on the problem. The diagnostic test will probably take one hour, so the labor costs will likely be between $70 and $150, depending on the repair shop’s labor rates.
How do you reset the accelerator pedal position sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
How much does a throttle position sensor cost to replace?
The average replacement cost for the throttle position sensor is anywhere from $110 to $200. The parts cost is anywhere from $75 to $105 while the labor cost is anywhere from $35 to $95.
Where is the throttle pedal position sensor switch?
Meanwhile, the pedal position switch is usually part of the accelerator pedal assembly. Both of these sensors detect the force of the driver’s foot and provide precise input about the power needed from the engine and how urgently this power is needed.
Where is the throttle position sensor located?
A throttle position sensor (TPS) is a sensor used to monitor the air intake of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle.
Where is the accelerator pedal position sensor?
The accelerator pedal position sensor is located inside the accelerator pedal. In some cases, it is possible to replace just the sensor – but on other car models, you have to replace the whole accelerator pedal.
How do you test a throttle position sensor with a scanner tool?
Use live data graphing if your scanner supports it. Slowly push the accelerator pedal as you observe the live data. The graph should be a straight line with a positive slope. If it (the line) changes abruptly as you press the pedal, that means the TPS is faulty.
What causes a throttle position sensor code?
Code P0122 is triggered when your vehicle’s Engine Control Module (ECM) detects that your Throttle Position Sensor (TPS) circuit A is reporting an output voltage that is below its expected voltage. Depending on your vehicle, your TPS lower output voltage limit should be around . 17 to .
How do I clean my throttle body?
Zitat von Youtube: Go ahead and relieve the pressure remove. It and then just let it close nice and gentle notice we've still got a little bit of debris on this side of the throttle plate.