P2453 is a diagnostic trouble code (DTC) for “Particulate Matter Trap Differential Pressure Sensor Signal Performance“. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
Where is the DPF pressure sensor located?
engine compartment
The DPF differential pressure sensor is usually mounted in the engine compartment to protect it from heat. The sensor is connected to the engine control unit (ECU) by an electrical connector and connected to the DPF via two silicon hoses.
What causes low DPF pressure?
A DPF pressure drop increases with increase in the soot mass accumulated in the DPF. Small soot mass accumulation results in lower DPF pressure drop, while high soot mass accumulation would yield higher DPF pressure.
Can you clean a DPF pressure sensor?
In order to burn it clean, the de-installed DPF is put in a burning oven, where it is heated until all remaining soot is burned to ashes. Subsequently, the filter is blown clean with pressurised air until all ashes are completely removed. Rinsing is in fact blowing the filter clean with a watery cleaning solution.
How do you check differential pressure sensor DPF?
Zitat von Youtube: Blocked. Part of the process is checking what's called the pressure differential sensor now that thing determines. The pressure before the DPF and then after the DPF to make sure that there's no
How do I fix error code P2453?
What repairs can fix the P2453 code?
- Replacing the fuel filter.
- Repairing or replacing wiring or connectors that are associated with the fuel filter pressure sensor.
- Replacing the fuel filter pressure sensor.
- Replacing the powertrain control module.
How do you fix a DPF pressure sensor?
Zitat von Youtube: There you can even follow the pipe work and see where it then goes into the the dpf. If we just take a closer look here you can see you got the hose clamps there they just need undoing.
How do you unblock a DPF filter?
If you get a warning light showing that the filter’s blocked, it should be possible to complete an active regeneration cycle and clear the warning light by driving for 10 minutes or so at speeds over 40mph.
How do you reset a DPF pressure sensor?
Zitat von Youtube: We can just select reset DPS at the bottom here and that would allow us to reset any vehicle. In case connectives like GM manual select we want DPF service reg ignition then we want chevy.
How much does it cost to replace a DPF sensor?
The cost of a diesel particulate filter replacement can vary greatly depending on engine power and vehicle make. However, the average DPF replacement cost is around £1,000-£2,000 in the UK. However, the usual price range can be between £750-£3,000.
What are the symptoms of a faulty DPF?
A slight increase in fuel consumption. Increased idle speed. Deactivation of automatic Stop/Start. A hot, acrid smell from the exhaust.
How do you clean a DPF filter at home?
Zitat von Youtube: If you can't get hold of ph up then you can also use sodium hydroxide drain cleaner or dishwasher tablets or a strong degreaser. If it is a product that dissolves.