P2614 FORD code

P2614 is a standard OBD-II trouble code dealing with the camshaft position sensor. The code is triggered when the powertrain control module (PCM) is detecting improper amounts of voltage from the camshaft position signal output circuit.

What does code P2614 mean?

Camshaft Position Signal Output Circuit

OBD-II Code P2614 is defined as a Camshaft Position Signal Output Circuit/Open. The Camshaft Position Sensor measures the exact rotational position of the camshaft. This provides a critical data signal used by the engine control module (PCM) to control the fuel injectors an ignition coils.

How do I fix code P2617?

What repairs can fix the P2617 code?

  1. Repairing or replacing the crank sensor wiring harness or connector.
  2. Replacing a shorted crank sensor.

What does the camshaft position sensor do?

This sensor negates the need for manual distributor timing. The camshaft position sensor is used to determine which cylinder is firing to synchronize the fuel injector and coil firing sequence.

What does code P0346 mean?

P0346 code definition

The appearance of the P0346 code indicates that the PCM has detected an incorrect voltage or waveform reading from the engine bank 2 camshaft sensor A camshaft position sensor circuit.

What is Ficm sync?

The FICM uses CMPO (Camshaft Position Sensor Output) and CKPO (Crankshaft Position Sensor Output) signals, which are sent by the PCM, to calculate FICM SYNC. FICM SYNC is calculated by the FICM and is the correlation between the camshaft pin and the crankshaft triggers.

Where is the crank sensor on a 6.0 Powerstroke?

Zitat von Youtube: Okay I'm just showing you on this engine here where it's located. And kind of the difficulty in getting to this. But this is the front obviously we come over here to the passenger side.

What are the symptoms of a faulty camshaft sensor?

A glowing check engine light, stalling, poor acceleration and bad fuel mileage are all possible signs your camshaft position sensor may be failing. Gone are the days of carburetors and distributors, replaced by a variety of sensors that help a car’s computer get the maximum performance out of the engine.

What happens if camshaft position sensor is bad?

The camshaft position sensor monitors the motion of your camshaft so that the ECM in your car can regulate fuel flow, timing, and emissions output. When camshaft position sensors go bad they can cause rough idle, poor fuel economy, engine misfires in the higher end of your RPMs range, or a lack of power.