P2635 CHEVROLET code

A P2635 code is a generic powertrain code related to computer output circuit issues. It means that the fuel pump ‘A’ is registering a low flow, or one not within the preset parameters. Codes related to a P2635 include: P0627: Fuel Pump A Control Circuit/Open.

What does fuel pump a low flow performance mean?

What causes this problem with the Fuel Pump “A” Low Flow/Performance? The fuel pump has multiple damages which may have happened because of damaged brushes, bearing or armature. Defective fuel pump relay. Non-functional or damaged fuel pump driver. Low fuel.

How do I fix code p069e?

Removing or replacing a faulty fuel pump controller or damaged fuses and relays. Replacing the fuel pump controller with an updated version if the existing one is defective. Repairing or adjusting wiring harnesses to make sure they are not shorted, grounded, broken. Adjusting the vehicle’s voltage shutoff (inertia) …

How do you test a fuel pump control module?


Zitat von Youtube: You would jumper. The red and white wire to the grey water and your black wire to the pink wire. I know it's backwards but you jumper those and you should be able to hear the pump cycle.

What is fuel pump primary circuit?

OBD-II Code P0230 is defined as a Fuel Pump Primary Circuit. The Fuel Pump enables the transfer of fuel from the fuel tank to the fuel injectors in the engine. The Fuel Pump is controlled by the engine computer (PCM) or the Fuel Pump Control Module (most newer vehicles).

How do you reset a fuel pump control module?

The fuel pump shut-off switch has a red reset button on top of it.



Should your vehicle shut off after a crash, you may restart your vehicle:

  1. Switch off the ignition.
  2. Switch to start position.
  3. Switch off the ignition.
  4. Switch on the ignition to re-enable the fuel pump.
  5. If vehicle does not start, repeat steps 1 through 4.


How do you bypass a fuel pump control module?

Zitat von Youtube: These are going to the fuel pump. So if you jump right these wires right here these two outer wires together and the two grounds together it'll bypass. The control module.