When you see a P2733 diagnostic trouble code, it means that your car’s computer can’t control the hydraulic pressure inside the transmission. This will lead to a number of transmission problems like slipping, delayed shifts and engine stalling.
How do you change a transmission pressure control solenoid?
Zitat von Youtube: First thing we need to do is to remove the negative battery cable from the battery. Next thing we need to do is to remove the air box cover it has 5 Phillips head screws.
What does code po796 mean?
P0796 code definition
The presence of the P0796 code in the PCM means that an abnormal reading from the electronic pressure control solenoid, or the related circuit, was detected.
What does pressure control solenoid stuck off mean?
Pressure control solenoids are spring-loaded devices that the engine/transmission control modules use to direct the flow of pressurized transmission fluid to change gears. If the computer is unable to properly control pressure control solenoid ‘A’, then it will store a P0746 diagnostic trouble code.
What is a transmission pressure control solenoid?
Transmission Pressure Control Solenoid: DESCRIPTION
The transmission pressure control solenoid controls the fluid pressure to the internal friction plate clutches or drum bands. A bad or failing transmission pressure control solenoid can cause slipping, which can result in the transmission overheating.
How much does it cost to replace a shift solenoid?
$200 to $500
Shift Solenoid Repair and Replacement Cost
The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700.
How do you check a transmission pressure control solenoid?
Zitat von Youtube: Apply power or 12 volts to one of the two wires. Then using a multimeter probe at the other wire.