P2761 is a specific OBD-II code that indicates a problem with the main circuit of the pressure control solenoid within the TCC being in an open position. The TCC connects the turbine shaft to the torque converter’s shell, creating a one-to-one connection between engine output and transmission input.
How do I fix error code P2761?
What Repairs Will Fix P2761?
- Change the transmission fluid and filter.
- Repair transmission fluid leaks.
- Clean corrosion from connectors.
- Repair or replace wiring.
- Replace faulty torque converter clutch pressure control solenoid.
- Repair or replace a faulty torque converter clutch.
- Repair or replace defective torque converter.
Where is the torque converter clutch circuit located?
The torque converter is located between the rear of the engine and the front of the transmission. Inside this device is the torque converter clutch (TCC)—a component made up of a friction material that locks the converter shell onto the turbine shaft.
How do I fix error code P0740?
Repairs that can fix the P0740 code may include:
- Replacing the torque converter clutch solenoid.
- Replacing the torque converter or clutch.
- Adding or replacing transmission fluid and filter.
- Replacing the powertrain control module.
- Overhauling the current transmission.
- Replacing the transmission with a brand new one.
What can cause a P0741 code?
What causes the P0741 code?
- Faulty TCC.
- Faulty torque converter lockup solenoid.
- Internal short in the TCC solenoid.
- Wiring to the TCC solenoid that is damaged.
- Faulty valve body.
- Faulty Transmission Control Module (TCM)
- Faulty Engine Coolant Temperature (ECT) sensor.
- Damage of the wiring harness to the transmission.
How do you bypass a TCC solenoid?
To bypass the shift and TCC solenoids, you simply need to connect standard 194 light bulbs to these individual circuits coming from the PCM and then connect the other side of the bulbs to ignition B+. The light bulbs will then serve as a “load” which will simulate the solenoids.
What does shift solenoid B Electrical mean?
What the P0758 code means. Shift solenoid B allows the transmission to shift between second and third gear. If the PCM records code P0758, it indicates that the PCM cannot see the proper change in engine RPMs or the correct increase in road speed that should be happening during a shift from second to third gear.
How do you fix a torque converter clutch circuit that is stuck off?
What Repairs Will Fix P0741?
- Replace the torque converter clutch solenoid.
- Replace the torque converter or clutch.
- Change transmission fluid and filter.
- Repair/replace damaged wiring and connectors.
- Repair/replace TCM or ECU.
- Install a rebuilt or remanufactured transmission.
How much does it cost to replace a torque converter clutch solenoid?
The torque converter itself is relatively inexpensive (between $150 and $350, depending on the vehicle), but 5-10 hours of labor is involved since the transmission must be removed in order to replace the torque converter.
Torque Converter Replacement Cost.
| Repair | Cost Range |
|---|---|
| Transmission Shop | $600 to $1000 |
How do you check a torque converter clutch?
Put the pedal to the metal While pressing on the brake pedal, press the accelerator to the floor for two to three seconds. Don’t exceed five seconds, or you risk blowing out the transmission. The RPM the engine maxes out at is the stall speed.
How much is a torque converter clutch circuit?
On average individual solenoids cost between $15-$30, with prices reaching as high as $100, according to Autoservicecosts. Depending on the number of solenoids you need to replace and service time, labor costs will range from $70–$150.