What the P0341 code means. P0341 is an OBD-II generic code that says the engine control module (ECM) detected the engine camshaft position sensor circuit is not within specifications. The sensor pulses do not correlate to the pulses of the crankshaft sensor.
Can I drive with a P0341 code?
Trouble code P0341 should be diagnosed and repaired as soon as possible. Not recommended, however, you may drive your vehicle while trouble code P0341 is present unless the engine stall or stumbling is is severe enough to hinder proper vehicle operation. Erratic engine speed may be noticed.
What does error code P0341 mean?
Zitat von Youtube: If you are getting a po341 error code this video is going to show you two practical solutions to fix the error code at home use the zeus app to scan your vehicle. And see the error code po341. It
Where is camshaft position sensor a bank 1 located?
Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.
Can low oil cause a P0341 code?
I have also read that sometimes P0341 can also just be from low oil level. If the oil level is very low, not enough oil is present to feed the N205 allowing proper adjusting.
How do you fix a camshaft position sensor?
Zitat von Youtube: If it has repair the leak to prevent the new sensor from being damaged. Check to make sure the o-ring from the sensor hasn't fallen into its hole push. The new sensor into place and replace the bolt.
What can cause a cam sensor code?
What are the Possible Causes of the P0340 Code?
- Failing or defective camshaft position sensor.
- Circuit problems (e.g., damaged wiring, loose connections)
- Errors in the powertrain control module (somewhat rare)
- Damaged camshaft position sensor reluctor wheel.
- Problems with internal engine timing components.
What is bank1 sensor B?
Bank 1 is the side of your engine that has the cylinder 1, while sensor B refers to the exhaust camshaft side. Some car manufacturers have their own description of the P0017 code, such as GM (more specifically, Chevrolet).
What side of engine is Bank 1?
Bank 1 and bank 2 simply refer to either side of the engine. Bank 1 is on the side with cylinder 1. Bank 2 is the side with cylinder 2. Most commonly Bank 1 is towards the front of the car if it has a transverse engine.
What is a camshaft position sensor A circuit Bank 1?
Diagnostic trouble code P0341 stands for “Camshaft Position Sensor “A” Circuit Range/Performance (Bank 1 or Single Sensor).” It is triggered when the powertrain control module (PCM) detects a problem with the signal being sent by the camshaft position sensor.