U0107 GMC code

Code U0107 stands for Lost Communication with Throttle Actuator (TAC) Module. Older vehicles use a mechanical throttle linkage to connect the gas pedal to the throttle. Modern vehicles, however, do not have a throttle linkage. Instead they have an electronic throttle body.

Where is the TAC module located?

The TAC module is mounted on the driver’s side firewall under the corner brace. There are 2 connectors plugged into the bottom of it, one 10 pin and one 16 pin.

What causes throttle actuator control?

Zitat von Youtube: The throttle actuator control replaces. The need for mechanical linkage between the throttle body and the accelerator pedal.

What is a throttle actuator control module?

Product Description. An ACDelco GM Original Equipment Fuel Injection Throttle Control Actuator Module is an electrically operated motor assembly that controls the throttle plate(s), and is a GM-recommended replacement for your vehicle’s original component.

How do I fix code P1516?

Zitat von Youtube: Stop driving and repair your vehicle immediately. It indicates that the pcm has determined an out of range condition between the predicted and the actual position of the throttle.

How do I fix code U0107?

How to diagnose and repair U0107

  1. Perform a preliminary inspection. Sometimes U0107 can pop up intermittently, or it can result from a dead battery. …
  2. Check the battery. Like any other module, the TAC needs proper battery voltage to operate. …
  3. Check for other DTCs. …
  4. Check for a faulty control module.

How do you fix a throttle actuator control system?

What repairs can fix the P2111 code?

  1. Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
  2. Clean the throttle body. …
  3. Replace the throttle body. …
  4. Replacing the PCM. ( …
  5. Repair the wiring.

Where is the throttle actuator control system?

The throttle controller is located on top of the engine between the air intake and the intake manifold.

How do you test a throttle actuator?

Zitat von Youtube: And i'm placing the multimeter in ohms mode. And i'm getting a resistance reading of 3 ohms. And this resistance value lets me know that the throttle actuator motor is ok in this throttle body unit.

Where is the throttle position sensor located?

A throttle position sensor (TPS) is a sensor used to monitor the air intake of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle.

How much does a throttle actuator cost?

The throttle body part will typically cost between $200 and $500, depending on the type of car that you drive. Labor costs for this kind of repair are typically relatively low, so you can expect to pay between $50 and $150 to have the part professionally installed.

How do I clean my throttle actuator control?

Zitat von Youtube: Remember pull the tab. Push. It in to the component. And then remove it the throttle body itself is held in with four bolts for this.